Head Unit
Information on this page is incomplete due to lack of information found in research. Any information found is present, but may not assist with specifics such as plug connector housing part numbers and additional feature pinout information.
After a loss of power for an extended period of time, power to the Keep Alive Memory (KAM) inside the stereo is lost, resulting in an error on reconnection where the display will simply read c0de. If this happens, a 4-digit pin code is required, where each number entered is a number between 1-6, using the channel buttons on the bottom of the unit. Simply enter the code and the radio will regain functionality.
If the code is lost there is currently no known way to “calculate” the pin code based on the numbers on the stickers on the unit, nor is there a way to calculate based on the vehicles VIN or Engine Number. These rumours have proliferated throughout AU Falcon related forums for years but has been confirmed false by ASL Automedia, who are only able to decode based on a previously obtained database.
Brute-forcing the password is not recommended due to the 1,296 possible values and the increasing failure timeout between repeated attempts. Use of a service such as that provided by ASL Automedia, a wrecker replacement radio with provided code, or an aftermarket solution, should be sourced.
The connector used for the head unit of the AU Falcon is specific to this model, and to date no further information has been ascertained on who manufactures these parts. The following information about the connector has been collected however despite this:
For the following information, assume you are looking at the loom end connector, with the clip facing up
01 |
02 |
03 |
04 |
05 |
06 |
07 |
08 |
||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
09 |
10 |
11 |
12 |
13 |
14 |
15 |
16 |
17 |
18 |
19 |
20 |
||||||||||||
For EAI Wire Color, this is the “universal standard” colors within an aftermarket loom wiring harness. Colors in brackets are based on a rewiring loom kit from Aerpro, Product code
711053
Every effort has been made to make this information accurate, however wire colors may be different depending on series
| Pin # | Function | EAI Wire Color | Wire Color |
|---|---|---|---|
| 01 | Constant 12v | Yellow | Yellow/Grey |
| 02 | Dimmer Input (Not required) | Orange | Brown/Grey |
| 03 | Right Front Speaker + | Grey | Grey/Green |
| 04 | Left Front Speaker + | White | Orange/Grey |
| 05 | Right Rear Speaker + | Purple | Blue/Red |
| 06 | Left Rear Speaker + | Green | Pink/Green |
| 07 | Dimmer Output (Not required) | Orange | Blue/Red/Grey |
| 08 | GND | Black | Black/Blue |
| 09 | Accessory Power 12v + | Red | Purple/Pink/Grey |
| 10 | N/a | N/a | N/a |
| 11 | N/a | N/a | N/a |
| 12 | Right Front Speaker - | Grey/Black | Grey/Black |
| 13 | 12v Antenna (Not required) | Blue | Red/Blue/Grey |
| 14 | Left Front Speaker - | White/Black | Orange/Black |
| 15 | Right Rear Speaker - | Purple/Black | Blue/Black/Grey |
| 16 | Mute | Pink | Light Green/Grey |
| 17 | Left Rear Speaker - | Green/Black | Pink/Black |
| 18 | External Controls | (Brown) | Red/White |
| 19 | Mobile Office Audio In | (Pink) | Pink |
| 20 | Mobile Office Audio Out | (Black) | Blue |