AU Ford Falcon - SPUD Project




Rear Lights Connector


Rear Lights Connector

The rear light connector can be a great location to wire in Accessory trigger wire(s) for auxiliary system such as a reversing camera. In the case that you would like to tap into this wiring without soldering or modifying the vehicles own wiring loom, the following information could be found to be useful.

Plug Type

The plug used for the tail light connector is known as a 250 Series Quick Connect 6-way connector. There are many manufacturers for these connectors such as Narva, and as such it should be relatively trivial to find one from an Automotive Shop

Rear connector car loom end plug Rear connector light end plug

Pictures of the car loom end connector (female terminal housing) and the light end connector (male terminal housing) respectively

Pinout

Use the following diagram and pinout list for reference. This diagram assumes that the clip is facing up and you are looking at the female housing connector (the loom end wiring connector)

01 02 03
04 05 06
Pin Colour Purpose
01 Red/Black Reverse Lights
02 Green/Red Brake Lights
03 Green Indicator/Hazards
04 Brown Tail Lights
05 Black Ground
06 N/a Not populated

Page printed from The AU Falcon SPUD Project, visit https://digi-ron.github.io/AU-Falcon-SPUD-Project/ for more!